Subject: 504 fix Date: Sun, 5 Jan 2003 16:03:27 +1030 Status: Normal From: "Marc " It was reported that dlink dsl 300s had a problem gaining synch where alcatels could do this okay. Here is the suggested fix. Works for 504s too. -Plug in the Grey Serial cable between com port and socket on modem. -Open Hyper terminal or some other terminal software. - Connect to the com port 9600 8 none 1 - press enter and you should be greeted with a prompt usually : 192.168.1.1> - type the following. enter after each line itex line down itex mode ansi config save restart Marc Lok Internode PO Box 284, Rundle Mall 5000 Level 3, 132 Grenfell Street, Adelaide 5000 Phone: (08) 8228 2999 Fax: (08) 8235 6999 Web: http://www.internode.on.net ------------------------------------------------------------------------ The contents of this e-mail and its attachments are confidential and may be subject to legal professional privilege and copyright. It is intended solely for the addressee. Access to this e-mail and its attachment by anyone else is unauthorised. No representation is made that this e-mail or any attachment is free of viruses and other defects. Virus scanning is recommended and is the responsibility of the recipient. If you are not the intended addressee, any disclosure, usage, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited. If you have received this communication in error, please advise the sender immediately by reply e-mail and delete this message from your computer. Thank you for your cooperation. ------------------------------------------------------------------------